License Plate Bracket For Triumph Street Triple 675 765 - 2009 to 2024

License Plate Bracket for Triumph Street Triple 675 and 765 (2009 to 2024)

The factory license plate bracket on the Triumph Street Triple is a wide plastic assembly that spans the full width of the rear subframe, integrating the plate, turn signals, and plate light into one bulky unit. This assembly hangs visibly below the tail unit and adds width that conflicts with the Street Triple's narrow, stripped-down proportions. This license plate bracket replaces that assembly with a lightweight CNC-machined aluminum unit that holds the plate in a clean, low-profile configuration, significantly tidying the rear appearance of the bike.

The bracket is machined from billet 6061 aluminum with anodized black finish. It mounts to the existing rear subframe bolt holes on the Street Triple platform — the mounting points are consistent across the 675 and 765 generations — using the supplied stainless steel hardware, with no cutting or permanent modification. An integrated LED plate light meets standard illumination requirements. Turn signal relocation mounts and wiring extensions are included so the factory signals can be repositioned without harness modification. The complete kit installs in approximately one hour.

At $149.90, this bracket suits any Street Triple owner looking to refine the rear end. The Street Triple 675 and 765 platform spans 2009 through 2024 — a remarkably long continuous production run on the same basic chassis architecture — which means this single bracket fits 15 years of production across multiple engine, suspension, and electronics updates, but the same subframe rear geometry. This makes it one of the most widely applicable Street Triple accessories in the market.

Confirmed fitment for the Triumph Street Triple 675 from 2009 through 2016 (Daytona, RX, and all standard variants) and the Street Triple 765 (S, R, RS) from 2017 through 2024. Both generations share the rear subframe plate mounting geometry. The Moto2 Limited Edition uses different rear bodywork and is not confirmed.

Frequently Asked Questions

Does it fit both the 675 and the 765 with no modification?

Yes. The rear subframe bolt hole pattern at the license plate mount location is unchanged between the 675 (2009-2016) and 765 (2017-2024) generations of the Street Triple. One bracket fits both platforms using the same mounting hardware and wiring connections. No adaptation plates or spacers are required.

Does the included plate light produce enough illumination for night use?

The integrated LED plate light is specified to produce sufficient illumination for standard plate visibility requirements. LEDs maintain consistent output across their rated life and do not dim progressively like incandescent bulbs. For very dark riding environments or jurisdictions with strict plate illumination requirements, an additional supplementary light strip can be added to the bracket without modification.

Free shipping on every order in the US. Every part is covered by a 1-year warranty and can be returned within 30 days of receipt.