Rear Frame Hole Caps For CFMOTO 800MT / 700MT - 2021 to 2025

Rear Frame Hole Caps For CFMOTO 800MT / 700MT - 2021 to 2025

When saddlebag mounts or side bag supports are removed from the CFMOTO 800MT or CFMOTO 700MT, the rear frame is left with open mounting holes. These rear frame hole caps snap directly into those openings, keeping out road debris, moisture, and dust.

Each plastic cap clicks into the frame without tools or hardware. The set of four covers all mounting points, restoring a clean finish to the rear subframe.

Why it makes a difference

The caps seal the open frame holes left behind when saddlebag mounts are not installed, preventing dirt and water from collecting inside the frame tubes. Four plastic caps are included, covering every mounting point on the rear subframe.

Each cap snaps into place using the existing hole — no drilling, no adhesive, no modification to the frame. Removal is equally straightforward if you decide to reinstate the saddlebag mounts later.

The black finish matches the frame and surrounding bodywork on the CFMOTO 800MT and CFMOTO 700MT, keeping the rear section looking tidy whether the bike is ridden bare or with soft luggage attached.

Installation

Bolt-on fitment. No drilling, no cutting and no permanent modification to your motorcycle. Clean the frame holes of any dirt or debris. Align each cap over a frame mounting hole. Press firmly until the cap clicks and seats flush with the frame surface. Repeat for all four holes.

Available in Black.

Fitment

This part is listed for CFMOTO 800MT (2021–2025) and CFMOTO 700MT (2025–2025). Check your model year and trim against the list above before ordering.

Questions riders ask

Will these caps fit both the 800MT and the 700MT?

Yes — according to the listing, these caps are compatible with the CFMOTO 800MT (2021–2025) and the CFMOTO 700MT (2025).

How many caps come in the set?

The set includes 4 caps, covering all rear frame mounting holes.

All orders ship free, and every product is backed by a 1-year warranty.